Bentley.com>Comunidades>Haestad Solutions
 HAESTAD SOLUTIONS

Be Prepared to Respond to Emergencies, with WaterGEMS/WaterCAD and HAMMER
Vea este eSeminario por capítulo:
Estos vídeos se abren directamente en su media player.

View the full session (26 min, 34 sec)
(you will be requested to log in to see this video)

 

Overview:

1 - Introduction
2 - Demonstration in HAMMER and WaterGEMS: negative pressures due to transients lead to the entrance of a contaminant in the system.
3 - Demonstration in WaterGEMS: flushing of the contaminated water.
4 - Demonstration in HAMMER: addressing of the surge problem by adding a hydro-pneumatic tank.
5 - Conclusion and Q&A

 
Fuentes:
More water eSeminars (live and recorded)
Presentado por:   Mike Rosh, Application Engineer, Bentley
Resumen: 

Watch how HAMMER and WaterGEMS/WaterCAD can help engineers be more responsive to emergencies and customer complaints.

This video shows the simulation of negative pressure problems and resulting contamination. It also shows the selection of the best operational strategies to address these problems in the short and long terms.
Lo que Vd. Puede aprender:
  • Integrate your water modeling (WaterGEMS/WaterCAD) and transient analysis (HAMMER) work.
  • Detect the cause of potential problems and simulate their effects in the water system: in this case, an odor problem is reported in a specific region of the water network.
  • Select a short-term solution: in this case, the contaminated water is flushed.
  • Select a long-term solution: in this case, a hydro-pneumatic tank is installed to suppress the transient.
Imágenes:
¿Tiene problemas para ver el eSeminario? >> Ayuda de Video

De vuelta al índice de eSeminarios de Haestad Solutions