Bentley.com>Skupiny>Haestad Solutions
 HAESTAD SOLUTIONS

Be Prepared to Respond to Emergencies, with WaterGEMS/WaterCAD and HAMMER
Kapitoly
These videos open directly into your media player.

View the full session (26 min, 34 sec)
(you will be requested to log in to see this video)

 

Overview:

1 - Introduction
2 - Demonstration in HAMMER and WaterGEMS: negative pressures due to transients lead to the entrance of a contaminant in the system.
3 - Demonstration in WaterGEMS: flushing of the contaminated water.
4 - Demonstration in HAMMER: addressing of the surge problem by adding a hydro-pneumatic tank.
5 - Conclusion and Q&A

 
Další zdroje
More water eSeminars (live and recorded)
Přednášející:   Mike Rosh, Application Engineer, Bentley
Shrnutí: 

Watch how HAMMER and WaterGEMS/WaterCAD can help engineers be more responsive to emergencies and customer complaints.

This video shows the simulation of negative pressure problems and resulting contamination. It also shows the selection of the best operational strategies to address these problems in the short and long terms.
Co se můžete naučit:
  • Integrate your water modeling (WaterGEMS/WaterCAD) and transient analysis (HAMMER) work.
  • Detect the cause of potential problems and simulate their effects in the water system: in this case, an odor problem is reported in a specific region of the water network.
  • Select a short-term solution: in this case, the contaminated water is flushed.
  • Select a long-term solution: in this case, a hydro-pneumatic tank is installed to suppress the transient.
Náhledy (screenshots):
Máte problémy spustit eSeminář? >> pomoc pro zhlédnutí videa

Zpět na seznam eSeminářů kategorie „Haestad Solutions“